Beko washing machine
error codes

No or too little water entering the drum (water inlet problem)

Check the tap is fully open, check inlet hose for kinks/blockage, clean the filter at both ends, test water pressure with another tap in the house

Water drain problem (often a kink in the hose)

Check inlet/drain hose for kinks and blockage

Problem with the motor

Check the plug, run a programme with an empty drum (if overloaded), otherwise wait 30 min and try again. If it persists: technician needed

Leak - water on the base plate

Turn off the tap, disconnect the machine from power, check drain/filter/hoses and detergent drawer for leaks

Water drain problem (blocked filter or drain hose)

Open the flap bottom right, remove and clean the filter (watch for coins etc.), place a towel underneath while emptying

Problem with the NTC sensor (temperature sensor)

Professional help usually needed, authorised Beko service technician required to replace the sensor/circuit board

Heating element has an open circuit (circuit interrupted, water not heated)

Technician needed

Door lock - open circuit

Check the plug is properly in the socket, push the door firmly shut until it clicks, deactivate child lock (hold first two function buttons for 3 sec)

Door lock - closing fault

Same as E09 - close door firmly, check child lock. Note: after a programme ends it takes 1-2 min before the door lock releases (normal)

Motor fault (drum doesn't turn, or turns incorrectly)

Always needs a technician - often worn carbon brushes, requires technical expertise

Too much foam (stops without spinning)

Use less detergent next time

Imbalance (stops without spinning)

Place the machine on a hard, stable surface, distribute laundry evenly in the drum

Temperature sensor fault (possibly interrupted contact to the thermostat)

Have the thermistor resistance checked with a multimeter (normally ~4700 Ohm at 25°C), technician needed for replacement if faulty