Is your AEG dishwasher showing an error code? Below you'll find all known error codes, what they mean, and what you can check yourself. All information has been researched and, where possible, verified with the manufacturer. Can't solve it yourself, or does the fault keep coming back? We often schedule a technician within 24 hours.
No or insufficient water inlet
Fully open the tap, test water pressure (10L bucket should fill within 1 min), check inlet/drain hose for kinks
Water drain problem (water not pumped out)
Detach and thoroughly clean the filters (refit correctly), check sink drain/siphon for blockage, check drain hose for kinks
Water protection (Aqua-Control) activated - leak to the safety base detected
Turn off the tap, switch off the appliance. Check spray arms for damage/blockage. If it persists: technician needed (deeper water issue, don't continue yourself for electrical safety)
Problems measuring the water level
Clean filters and check for obstructions
Problem with the motor or circulation pump
Try a reset (off/on). Check filters and remove obstacles. If the code keeps returning: technician needed
Fault with the heating element or temperature control
Cannot be fixed yourself, technician needed
Water temperature cannot be measured correctly (temperature sensor faulty)
Book a service appointment
Problem reading the door opener signal (door blocked or circulation pump flap not in correct position)
Book a service appointment
Problems processing signals from the main/control/steering modules
Book a service appointment
General technical fault
Switch the dishwasher fully off and restart
Water level too high
Check filters for blockage
Our certified technicians repair all AEG appliances, fast and with clear pricing upfront.
Schedule a repair →